Geo Knight/New press and new paper

[Jill]

Hi I’m new to the forever paper. I have my pressure set at medium (although I don’t really know the setting. When I press the laser light no cut, it is leaving some of the transfer behind. Is this due to pressure or heat? My heat is set at 354F.

[Anonymous]

Dear Jill,

first off all, thank you for your trust in our products.
I need some additional information to give you the best support:
Which printer are you using?
How long are you pressing?
What are you doing after opening the heat press?
What is the model of your heat press?

Best Regards.

[Jill]

We are using the OKI 711WT
We are pressing for 15 seconds
After press, we use an old tee to cool the transfer for 15 seconds (we have also tried 2-5 seconds).
We have a Geo Knight K20S

[Anonymous]

Dear Jill,

thank you very much for the information.
As I can see you are doing everything right.
I think it has something to do with the heat press. Maybe the temperature is not rising fast enough or the pressure is too low.
I would try it again by increasing the temperature to 375-390°F.
If you start to peel after rubbing with a cloth over it and you see some toner rests on the transfer paper, rub again for 1 or 2 seconds and continue peeling, Repeat this step untill it works fine without any toner on the transfer paper.

[Author]

Posts