The white in the print wont stick

[Anonymous]

I’m trying to make a print on a cycling jersey (Polyester). The dimension of the print is around 6.5 cm wide and contains a red line with some white text. Every time i try to make the transfer stick the inside the red line falls off. (Not everything but some of the letters) My heat pressure is set to 135°C and 2.3 bar for 30 seconds.

Note: If i upscale the print everything is fine then.

Is there someone who has tried this before?

[Anonymous]

Dear M. Neale,

please make sure that you are working like it is written in the current instruction.
You should use about 150-160°C and 90 seconds for the first step and 30 for the second step.

If a line is too thin and you see it is not working, make sure that you are using a thicker line.
Normally we can guarantee perfect results with line thicknesses of 0,5 pt.

[Author]

Posts